PSS WIN-PRO Service Version: Getting Started 4-1
System requirements
To install the PSS WIN-PRO system software you will need the system
features listed below:
• Operating system: Windows 2000/XP
• Processor: min. 1 GHz
• RAM: min. 256 MB
• Hard drive: ca. 500 MB of available disk space
• Graphics card: min. resolution 800 x 600 pixels, 65536 colours
(set small fonts)
• Serial port for downloading data to the programmable safety system.
If the programmable safety system has an ETH-2 interface, data can
also be transferred via Ethernet.
• To call up online help: Browser, compatible with HTML 3.2.
Recommended: Internet Explorer from Version 5.0, Netscape Navigator
from Version 5.0.
Installing
Install PSS WIN-PRO and enter the licence for the service version (see
also the section entitled “Licensing”). If you have a licence for the full
version, this will automatically contain the licence for the service version.
NOTICE
If there is already an older version of PSS WIN-PRO on your computer,
you will need to uninstall this version before installing the new version (see
section entitled “Uninstalling”).
The PSS WIN-PRO software must be installed on a hard drive:
1. Switch on your computer and start up the operating system.
2. Insert the CD-ROM into your CD-ROM drive.
3. If the CD does not start automatically, select “Run” from the Windows
Start menu. Enter “x:\setup.exe”, replacing x with the designation of
the CD-ROM drive. Click OK. The installation will start.
4. Follow the on-screen instructions to complete the installation.
Installation
To Next Page
Loading...
