5-14
Functions
PSS WIN-PRO Service Version: Getting Started
Display error stack of a unit on SafetyBUS p
The error stack of every device on SafetyBUS p can be displayed.
1. Connect computer
Connect your computer to the PSS (see also “Connect computer to
PSS”).
2. Start the SBp Configurator
From the Windows Start menu select
Programs
->
Pilz
->
PSS WIN-PRO
->
SafetyBUS p Configurator Service Version
or
click on in the PSS WIN-PRO toolbar.
3. Go Online
Select
Online -> Display SBp configuration of PSS
.
4. Insert information window
If the information window is not displayed, select
View -> Information
window
.
5. Select the error stack tab
6. Display error stack
Click on the unit whose error stack is to be displayed.
The error messages for the highlighted unit will be displayed. If the unit
is the MD, you will also receive general error messages for SafetyBUS p.
7. Display remedy
Double-click on the error message to display an explanation of the
error.
8. Refresh error stack
Select
Online -> Refresh error stack
to have the error stack
refreshed.
To Next Page
Loading...
