Dust Bag Removal
The machine has two dust bag options. A re-usable cloth
bag and a disposable paper bag. Monitor the dust bag
carefully and empty/change as needed. The dust
collection system will not operate effectively when the dust
bag is full. Under heavy burnishing conditions the dust
bag should be emptied/changed every hour.
1. Turn off the Burnish Motor.
2. Unscrew the knobs holding
the dust bag cover to the
shroud.
3. Pull the dust bag off the
dust tube.
4. Empty/Change dust bag.
Pad Pressure Adjustment
The pad pressure is set at the factory for optimal burnish
performance in most conditions. If the pad pressure
needs to be adjusted, follow the procedure outlined below.
Note: Pad pressure adjustments should only be
performed by a qualified technician.
1. Turn burnish switch off.
2. Remove back panel.
3. Adjust ball end to increase or decrease pad pressure
as shown in diagram.
Storage
1. Machine should be stored in a dry environment.
2. Store machine away from objects that may fall and
damage it.
3. Never store burnisher near an open flame or heat
producing device.
4. Make sure burnisher is cleaned properly by wiping
machine down with damp cloth before storing.
CAUTION! NEVER PRESSURE WASH MACHINE!
5. Disconnect batteries before storage.
Operation on Inclines
CAUTION! When using the machine, go slowly on
inclines.
CAUTION! Do not run burnish pad on an incline.
The maximum rated climb and descent incline is 6°.
Post Operation Checklist
Turn the machine OFF and perform the following checks:
Check for wire, string, or twine wrapped around the
burnish pad.
Check Wire fray or damage.
Empty the Dust Collection Bag.
Inspect batteries.
Plug in on-board battery charger.
Lubrication of Rear Casters
Each of the two rear
casters has two grease fittings.
Lubricate each caster with a
grease gun every 100 hours of
machine operation.
Caster Parking Brake
The two rear casters are equipped with brakes. To set
the brake, push down the "ON" side of the brake lever. To
release the brake push down the "OFF" side of the brake
lever. The caster breaks should only be used as a parking
brake if needed. Before moving the machine make sure
both breaks are released.
14
Decrease Pad
Pressure
Increase Pad
Pressure
To Next Page
Loading...
