Pioneer Eclipse PE300BU - Repacking and Transporting; Repacking the Machine

Maintenance
*These items must be performed with the proper tools and training. Contact a Amano Pioneer Eclipse Factory
Certified Technician unless you have the proper equipment and mechanical proficiency.
16
CAUTION! Machine and/or battery damage can occur if
the electrolyte level is above the bottom of the tube in each
cell.
CAUTION! Never use tap water to fill battery cells. Tap
water contains contaminants that will damage the battery.
Only use distilled water to fill battery cells.
Repacking the Machine
Refer to Unpacking section on page 5 and repack machine
using original packing materials and container.
Transporting the Machine
When shipping the machine, make sure the batteries are
disconnected and the machine is secured in the
transporting vehicle.
Operation Interval
Daily
Every
20 Hrs
Every
25 Hrs
Every
50 Hrs
Every
100 Hrs
Every
200 Hrs
Every
1000 Hrs
Empty/Clean Dust Bag

Inspect Pad Holder

Inspect Battery water level (Lead Acid only)

Check wiring harness for fray or cut

Check for loose/missing nuts or screws

Tighten nuts and screws

Check brushes on transaxle motor and burnish motor

Lubricate rear casters

Check Burnish motor ampere draw

Inspect Burnishing Head Assembly (30”)

Inspect Deck Drive Belt (30”)

Replace Drive Belt (30”) As Required