12
Fault Description Remedy
No
Display
No display on the charger, no LED indicators.
Check that the plug is connected to an
operating wall outlet. Check fuse. 20A fuse
MP265100.
a
Incorrect battery connection or no battery
connection.
Check the connection and the polarity of the
battery connection.
The maximum voltage admissible by the battery
has been exceeded. The charge cycle was
interrupted.
Restart the charge cycle. If problem persists,
battery pack may be damaged.
The maximum temperature has been exceeded.
The charge cycle was interrupted.
Restart the charge cycle. If problem persists,
battery pack may be damaged.
The maximum time for the charging phase
has been exceeded. The charge cycle was
interrupted.
Restart the charge cycle. If problem persists,
battery pack may be damaged.
The total safety time has interrupted the charge
cycle.
Restart the charge cycle. If problem persists,
battery pack may be damaged.
Internal charger fault. Replace battery charger.
Battery Charger Fault Codes
To Next Page
Loading...
