Battery Maintenance
The battery supplied with this machine is a sealed,
absorbed glass mat (AGM), maintenance free type. It
never needs servicing. When battery replacement is
necessary, use Amano Pioneer Eclipse part #:MP363200.
1. Push machine to level surface.
2. Turn off LP cylinder and remove it.
3. Disconnect the BLACK negative battery cable first.
Disconnect the RED positive battery cable last.
4. Loosen battery-retaining strap.
5. Lift out old battery and replace with new battery.
6. Secure battery with battery-retaining strap.
7. Connect the RED positive battery cable first.
Connect the BLACK negative battery cable last.
Note: Dispose of old battery in the proper manner. Most
auto parts stores accept used batteries for recycling.
Machine Storage
Only authorized, trained personnel should have access to
propane cylinders and machines.
1. Remove propane fuel cylinder when not in use
and store it outside in a storage cage in
accordance with NFPA Handbook 58
CAN/CGAB149.2. Do not release or bleed
propane inside the building. Please consult your
local Fire Marshal to ensure that you are in
compliance with local fire codes.
2. Store machine away from objects that may fall and
damage it.
3. Never store machine or fuel cylinders near an
open flame or heat-producing device.
4. Make sure machine is cleaned properly before
storing.
5. Never store machine with cylinders installed, or
store spare cylinders in an enclosed van or trailer.
6. Store machine in a dry location, temperature not to
exceed 120°F (50°C).
Repacking the Machine
Refer to Unpacking and repack the machine using original
packing materials and container. Store machine in a dry
location, temperature not to exceed 120°F (50°C).
Transporting the Machine
When transporting a propane powered floor machine with
the fuel cylinder installed, the cylinder should be securely
fastened with the service valve closed and the machine
should be secured in the vehicle. Any propane fuel
cylinders not installed should be securely fastened to avoid
movement and damage. Never store machine with
cylinder installed or store spare cylinders in an enclosed
van or trailer. It is a good practice to check propane
cylinders for overfilling before transporting them. If
overfilled, correct before loading them in the vehicle by
venting the excess propane outside in a safe area using
the bleeder valve.
Tire Maintenance
Tire pressure should be checked before each use. Tires
should have equal pressure. The recommended tire
pressure is located on the side wall of tire.
PROPOSITION 65 WARNING
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and reproductive
harm.
Batteries also contain other chemicals known
to the State of California to cause cancer.
Wash hands after handling.
19
To Next Page
Loading...
