( Installation )
---------------~/
section
(
),.
~.
-----------~/
~
Before installing the amplifier
AWARNING
•
To
ensure proper installation, use the supplied
parts in the manner specified. If any parts
other than those supplied are used, they may
damage internal parts of the amplifier, or
be-
come loose causing the amplifier to shut
down.
•
Do
not install in:
- Places where it could injure the driver or
passengers if the vehicle stops suddenly.
- Places where it may interfere with the dri-
ver,
such
as
on the floor
in
front of the dri-
ver's seat.
• Install tapping screws in such a way
that
the
screw
tip
does not touch any wire. This is im-
portant to prevent wires from being cut
by
vi-
bration of the
car,
which can result
in
fire.
• Make sure that wires are not caught in the
sliding mechanism of the seats, resulting in a
short-circu
it.
• When drilling to install the amplifier, always
confirm no parts are behind the panel and
protect all cables and important equipment
(e.g.
fuel/brake lines, wiring) from damage.
ACAUTION
•
To
ensure proper heat dissipation of the ampli-
fier, ensure the following during installation:
- Allow adequate space above the amplifier
for proper ventilation.
-
Do
not cover the amplifier with a floor mat
or carpet.
• Avoid routing wires through hot areas, such
as
near the heater outlet. Heat may damage
the insulation, resulting
in
a short-circuit
through the vehicle
body.
•
The
optimal installation location differs
de-
pending on the car model. Secure the ampli-
fier at a sufficiently rigid location.
• Firstly make temporary connections and
check to ensure the amplifier and system
op-
erate properly.
• After installing the amplifier, confirm that the
_____
.1.:
__
:
__
1.
__
-I
L
__
l
....
L
~I.
..
__
::>fJart:
lIrt:,JaU\aIIU
lUUI::>
Lall
ueea;:'IIY
re-
moved.C!J
Example
of
installation on
the
floor
mat
or
chassis
1
Place
the amplifier
in
the desired instal-
lation location.
Insert
the
supplied tapping
screws
(4
mm
x
18
m
m)
into
the
screw
holes
and
push
on
the
screws
with a screwdriver
so
they
make
an
im-
print
where
the
installation
holes
are
to
be
lo-
cated.
2 Drill 2.5 mm (1/8 inch) diameter holes
at
the imprints either on the carpet or di-
rectly on the
chassis.
3 Install the amplifier with the
use
of
supplied tapping screws (4 mm x 18 mm).
CD
Tapping-screws
(4
mm
x
18
mm)
@ Drill a 2.5 mm (1/8 inch) diameter hole
® Floor
mat
or chassis
[!J
En
CID
To Next Page
Loading...
Need help?
General
