16
En
Preparation
05
Preparation
Installing the Plasma Display
Location
• Avoid direct sunlight. Maintain adequate ventilation.
• The length of the system cable used to connect the Plasma
Display and the Media Receiver is about 3 m.
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
CAUTION
• If you place anything on the top of the Media Receiver it will
not receive enough ventilation and will not operate properly.
NOTE
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the
unit.
Using the optional PIONEER stand
• For details on installation, refer to the instruction manual
supplied with the stand.
Using the optional PIONEER speakers
• For details on installation, refer to the instruction manual
supplied with the speaker.
CAUTION
Operating Environment
Operating environment temperature and humidity:
+0°C to +40°C; less than 85% RH (cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or strong
artificial light)
Installing the Media Receiver
CAUTION
• Do not place a VCR or any other device on the top
of the Media Receiver.
• When installing, allow enough space on the sides
and above the Media Receiver.
• Do not block the side ventilation opening or the
rear exhaust opening of the Media Receiver.
CAUTION
Placing the Media Receiver alone in the vertical position can
result in product damage and malfunction.
Over 50 cm
Over
10 cm
PULL
OPEN
STANDBY/ON
ON STANDBY
TIMER
Plasma Display
Media Receiver
System cable
(approx. 3 m)
PULL
OPEN
STANDBY/ON
ON STANDBY
TIMER
Over 5 cm
Over 5 cm Over 5 cm
Over 10 cm
Exhaust
opening
Ventilation
opening
PULL
OPEN
STANDBY/ON
ON STANDBY
TIMER
PDP506XDE.book Page 16 Friday, June 17, 2005 3:08 PM
To Next Page
Loading...
