Basic Setup
04
42
En
Chapter 4:
Basic Setup
Important
•The procedure for setting the receiver operation
mode differs for the remote controls included with
the SC-LX83 and SC-LX73. For the SC-LX83’s remote
control, set the remote control operation selector
switch to RECEIVER. For the SC-LX73’s remote
control, press the button. When “set the
remote control to the receiver operation mode” is
indicated in these instructions, use the respective
procedure described above.
Changing the TV format setting
If the Graphical User Interface screen is not displayed
correctly, it may be that the TV system is set incorrectly
for your country or region.
1 Switch the receiver into standby.
2 While holding down
ENTER
on the front panel,
press
STANDBY/ON
.
The display shows RESET NO .
Use / to select PAL/NTSC PAL , and then use
/ to select PAL or NTSC.
Changing the frequency step
If you find that you can’t tune into stations successfully,
the frequency step may not be suitable for your country/
region. Here’s how to switch the setting:
1 Switch the receiver into standby.
2 While holding down
ENTER
on the front panel,
press
STANDBY/ON
.
The display shows RESET NO .
Use / to select FREQ STEP 9k , and then use
/ to select 9k or 10k.
Changing the OSD display language
(OSD Language)
The language used on the Graphical User Interface
screen can be changed.
• The explanations in these operating instructions are
for when English is selected for the GUI screen.
1 Switch on the receiver and your TV.
Make sure that the TV’s video input is set to this receiver
(for example, if you connected this receiver to the VIDEO
jacks on your TV, make sure that the VIDEO input is now
selected).
2 Set the remote control to the receiver operation
mode, then press
HOME MENU
.
A Graphical User Interface (GUI) screen appears on your
TV. Use /// and ENTER to navigate through the
screens and select menu items. Press RETURN to exit
the current menu.
3 Select ‘
System Setup
’ from the
Home Menu
.
4 Select ‘
OSD Language
’ from the
System Setup
menu.
5 Select the desired language.
6 Select ‘
OK
’ to change the language.
The setting is completed and the System Setup menu
reappears automatically.
RECEIVER
SC-LX83_73_DLPW.book 42 ページ ２０１０年５月１９日 水曜日 午後２時７分
To Next Page
Loading...
Need help?
General
