Need help?Do you have a question about the Pioneer SX-620 and is the answer not in the manual?
General| Type | Stereo Receiver |
|---|---|
| Tuning Range | FM, MW |
| Total Harmonic Distortion | 0.8% |
| Speaker Load Impedance | 4Ω to 16Ω |
| Frequency Response | 20Hz to 20kHz |
| Input Sensitivity | 200 mV (line) |
| Signal to Noise Ratio | 70dB |
| Power Output | 20 watts per channel into 8Ω (stereo) |
Details power output, distortion, sensitivity, and frequency response for the amplifier section.
Lists FM/AM sensitivity, selectivity, separation, and noise specifications.
Describes the function and effect of tone, balance, and loudness controls.
Includes power requirements, consumption, dimensions, and weight specifications.
Lists supplied items such as operating instructions and antennas.
Covers the power switch, power meter, speaker indicators, and function indicators.
Details the dial pointer, AM/FM tuning meter, and FM stereo indicator.
Describes the function selector for source selection and the tuning knob.
Explains the operation of bass, treble, balance, volume, and loudness controls.
Explains mode/muting, tape monitor, and speaker selection switches.
Describes the headphone output jack for private listening.
Illustrates the signal flow through the FM and AM tuner sections.
Shows the signal path from audio inputs to the output stages, including power supply.
Explains the FM/AM RF front ends, IF stages, and detector circuits.
Details the audio amplifier, equalizer, and MPX stereo decoder circuits.
Describes the circuit operation for the power level indicators.
Guides on removing outer panels like side, top, bottom, and front panels.
Identifies key components and parts on the front panel assembly.
Shows the layout of components on the rear panel and top internal views.
Detailed, illustrated steps for correctly stringing the dial cord.
Procedures for setting the correct idle current for amplifier channels.
Steps to calibrate the power output meter segments accurately.
Adjustments for FM front end tracking and multiplex decoder.
Steps for aligning the AM tuner stages for optimal performance.
Illustrates wiring connections on the main PC board and various assemblies.
Detailed electrical schematics for the entire receiver circuit.
Visual representations and types of semiconductors used in the unit.
Lists common components like fuses, lamps, switches, and transformers.
Comprehensive list of transistors, ICs, and diodes by part number.
Lists specific PC board assemblies and components for the tuner/AF section.
Details various passive components including capacitors, resistors, and coils.
Illustrates how external parts of the receiver fit together for disassembly.
To Next Page
