Pioneer XR-P310 - TUNING INTO STATIONS; Tuning Methods; AM;FM Noise Reduction and Mode; Station Memory and Display

TUNING INTO STATIONS
AM-NR/FM-MONO button DISPLAY button
FREQJST.
DOWN-TUNER-UP
SEs
ei
Operations indicated by the [ a j mark are performed with
the remote control unit.
12
<ARB1293>
En
® Broadcast reception is not possible unless an antenna is
connected, so be sure to connect one.
1 Press FREQ./ST. to select frequency
mode.
"TUNER" appears in the display.
2 Select AM or FM with BAND.
3 Press TUNER UP (+) for higher
frequencies or DOWN (-) for lower
frequencies.
The TUNED indicator lights up when a station of sufficient
signal strength is tuned in.
@ One step tuning
Press TUNER UP (+) or DOWN (~) and release quickly.
The frequency will change by one step* each time the
button is pressed. Press as many times as necessary to
tune in the desired station.
*One step
Australian model
U.S. and Canadian models
Muiti-veltage model
Depending on the position of the FM/AM CHANNEL STEP
switch on the rear panei, one step changes as follows.
{100 kH2/10kHz} position .. FM: 100 kHz, AM: 10 kHz
[50 kH2/SkHz] position .. FM: 50 kHz, AM: 9 kHz
-FM: 50 kHz, AM: 9 kHz
FM: 100 kHz, AM: 10 kHz
@ Auto tuning
Press TUNER UP (+) or DOWN (~} until the frequency
starts to change (1-2 sec.), then release it. The tuner will
automatically search for a broadcasting station and stop
when one is found, and the TUNED indicator lights up.
To search for another station, press again.
@ High speed manual tuning
Keep TUNER UP {+} or DOWN (J pressed. The frequency
changes continuously, and stops when the switch is
released.
AM-NR/FM-MONO button
During AM reception: Cuts out AM broadcast noise to
give you a much clearer sound,
During FM reception: Switches between stereo and
monaural modes when listening to a stereo broadcast. If
there is a lot of noise in the stereo position, switch to
MONO and the noise will be suppressed.
Last station memory
The last received AM and FM stations remain stored regardless
of function and/or POWER switching.
To change the display mode: ~
Each time DISPLAY is pressed, the display switches between
tuner mode and the current time.
DISPLAY
=>
47