Pitco 12 User Manual

TROUBLESHOOTING:
FRYING SYSTEM:
Should there be a problem with your machine, the following checks should be done prior to calling an Authorized
Service Company. Make sure the machine is operated correctly and that the Computer or Digital Display (when
installed) is programmed accordingly.
Make sure the pilot is litCheck pilot
Check for blown fuses. (Where applicable.)Fuses
Should be in the appropriate positionGas valve knob position
Make sure gas supply line is connectedGas to machine
Power switch should be in the ON position. (On RPB
machines ONLY the manual reset switch must be
pressed after there has been an interruption in power.)
Power switch on
Press Hi-Limit reset button. Mounted on cabinet side
behind door
Hi-Limit reset
Check main power to machine (When applicable.)Power to machine
HOW TO CHECKITEM TO CHECK
Check these items before calling your Authorized Service Company
Call Authorized Service CompanyShortening is leaking from fry tank
Check Thermostat calibration (Where applicable.)
Call Authorized Service Company
Oil temp too hot or Machine runs constantly
Call Authorized Service Company
Relight pilot per the manual
Machine will not maintain temp:
Is pilot lit? YES
NO
Gas valve knob position
Check pilot
Machine will not maintain temp:
Is machine still running? YES
NO
Power switch ON
Gas valve knob position
Fuses
Is Thermostat turned UP
Pilot lights:
Machine will not heat
Hi-Limit reset
Gas to machine
Gas valve knob position
Pilot will not light
Hi-Limit switch
Gas to machine
Gas valve knob position
Machine will not run:
Front panel lights are ON.
Power to machine (Where applicable.)Machine will not run:
No lights on the front panel
ITEM TO CHECKPROBLEM
Locate the problem in the chart below then follow the instructions in the above chart.
8

Pitco 12 Specifications

General

Brand	Pitco
Model	12
Category	Fryer
Language	English