What to do if controller is on and Pitco Fryer will not heat up?
If the controller is on but your Pitco Fryer will not heat up, allow the appliance to cool and reset the high temperature limit. If the SCBS thermal limit switch has tripped, depress the button on the thermal limit switch to reset it. If the problem continues, contact an authorized service company.
What should I do if my Pitco Fryer has a power failure?
If your Pitco Fryer experiences a power failure, wait five minutes after the power is restored before attempting to restart the appliance. This will allow time for any gas that may have accumulated in the burner or tubes to dissipate. To restart the appliance, follow the appliance start up procedure.
What to do if the controller does not activate on my Pitco SG6H Fryer?
If the controller of your Pitco Fryer does not activate, check the main building power supply. Ensure the controller is turned on and the power cord is securely connected. Also, check if the main circuit breaker has tripped and reset it if necessary. If the appliance fuse has blown, contact an authorized service company.
Why are there excessive air bubbles in the oil returning to the tank of my Pitco SG6H Fryer?
If excessive air bubbles are present in the oil being returned to the tank of your Pitco Fryer, ensure the pickup tube screen is tight and properly installed. Also, make sure the filter pan is completely pushed in to ensure a secure connection.
What to do if my Pitco Fryer experiences a high temperature limit?
If your Pitco Fryer experiences a high temperature limit, turn the appliance off and allow it to cool to room temperature. Add oil/shortening to the cook tank as needed. If equipped, press the high temperature reset button. The high limit switch is now reset, and the appliance is ready to start up.
Why is the oil/shortening returning to the tank slowly in my Pitco Fryer?
If the oil or shortening is returning to the tank of your Pitco Fryer slowly or not at all, change the filter paper. Remove and clean the strainer cap. Ensure the filter pan is fully pushed in.
How to fix a Pitco SG6H Fryer when the filter pump does not activate?
If the filter pump of your Pitco Fryer does not activate, reset the filter pump circuit breaker.
What to do if my Pitco SG6H computer controller still displays 'DRAINING' when the drain valve is closed?
If the drain valve is closed, but the computer controller still displays 'DRAINING' on your Pitco Fryer, verify that the drain valve handle is completely closed. If the issue persists, contact an authorized service company, as the drain switch may be improperly adjusted or defective.
To Next Page
General
