Do you have a question about the Pitco SSHLV Series and is the answer not in the manual?
Defines qualified personnel for installation and service.
Defines key terms used throughout the manual.
Specifies requirements for authorized equipment operators.
Specifies requirements for authorized equipment installers.
Details the components and function of the ignition system.
Steps to remove the controller front panel bezel.
Procedure to check transformer resistance using a multimeter.
Steps to remove the rear mounting bracket.
Procedure for replacing the seal kit on the filter pump.
Steps for replacing the circuit breaker on the filter pump.
Procedure to measure the incoming gas supply pressure.
Steps for replacing individual gas burners.
Steps to remove the basket lift cover.
Procedure to replace the basket lift transformer.
Steps to remove the filter pump and motor assembly.
Wiring diagram for heat control circuits.