Pitco SSHLV (ROV) Gas Fryers
14 Replacing Transformer/Power Box
DANGER
Prior to moving, testing, maintaining or repairing
any appliance, ensure it is emptied of all oil,
cool, disconnected from gas and all electrical
power. Failure to do so may result in property
damage, damage to your fryer, injury or death.
1.Remove service panel 4 screws. Entrance
box is located in rear left hand side. Cut zip ties
holding IEC connectors. Unplug Molex
connector and black IEC connectors. Note: on
multi bank units, it may be necessary to remove
an oil return line to remove the power box.
Make sure to reinstall and tighten this return
line when finished.
2. Remove two (2) phillip screws at top of the
entrance box.
3. Entrance box is located on sliding tabs, move
box toward rear and down towards the floor to
unmount from tabs.
4. Follow steps 1 through 3 in reverse order to
Re-install entrance box. When reinstalling take
caution not to bend tab on entrance box.
Position tab on entrance box with sliding slot.
Make sure to reapply zip ties to IEC connector
to keep in place.
L22-392 R1 34
To Next Page
Loading...
