Pitco SSHLV Series - Cleaning the Gas Valve Vent Tube

Pitco SSHLV (ROV) Gas Fryers
25 Cleaning the Gas Valve Vent Tube
! DANGER !
Prior to moving, testing, maintaining or repairing
your appliance, ensure it is emptied of all oil,
cool, disconnected from gas and all electrical
power. Failure to do so may result in property
damage, damage to your fryer, injury or death.
1. Bend the gas valve vent tube to allow for
removal.
2. Loosen nut at the base of the vent tube with
a 3/8 inch open-ended wrench and then
remove.
3. Clean the tube (not shown) and reinstall.
NOTE
Insure the vent tube is not reinstalled in an
upright position and insure there are no kinks in
the tube.
!
DANGER
!
Check for gas leaks after installation or servicing
of a gas fryer. Apply a leak detection solution to
all connections and joints to ensure there are no
bubbles or leaks. Failure to check for and correct
any leaks could lead to fire and/or explosion,
property damage, injury and death.
L22-392 Rev 1 52