Pitco SSHLV Series - Replacing the Burner Assembly; Replacing the Burner(s)

Pitco SSHLV (ROV) Gas Fryers
30 Replacing the Burner Assembly
30.1 Replacing the Burner(s)
NOTE
Gas valve can stay in place if replacing right
side burners. Only needs to be removed for left
side burners.
1. Drop the gas valve out of the way by holding
the elbow with a 7/8 inch wrench and removing
the swivel nut on the top gas valve fitting using
a 15/16 inch open-ended wrench.
2. Remove the pilot assembly. See “Replacing
an Igniter/Pilot Assembly” in Section 11.
3. Remove the two (2) screws, which hold the
rollout switch, using a 5/16 inch socket.
4.. Remove the screws, which hold the flame
jumper shields, using a 5/16 inch socket.
4. Remove all flame jumpers.
L22-392 Rev 1 61