Pitco SSHLV Series - Replacing the Pump Relay

Pitco SSHLV (ROV) Gas Fryers
24.2 Replacing the Pump Relay
1. Remove the two (2) screws, which hold the
pump relay, using a Phillips screwdriver.
2. Remove all wires on the pump relay using
needle-nose pliers. See “Simplified Wiring
Diagrams section 35.7”.
3. Remove the pump relay.
4. Reinstall the new pump relay by following
steps 1 through 2 in reverse.
L22-392 Rev 1 51