Pitco SSHLV (ROV) Gas Fryers
7 Blocked Drain (Auto Filter Only)
1. Display of “Blocked Drain- retry”. The drain is
not closing and the controller is not receiving
the signal that shows that the drain has been
closed.
Use ONLY the supplied drain cleaning tool to
remove any food debris or foreign object from
drain. Use of any other tool can damage your
drain valve and will void the warranty.
2. Once you cleared the drain press “YES”
button (6) key. If drain closes and the controller
receives the correct signal, check the drain
again to insure the cleaning tool has been
removed. Your fryer should go back into normal
mode. If not, your controller will scroll “block
drain”. You only have 3 times to try and
unblock drain before controller goes into lock
out.
3.If after three tries, the drain is still blocked the
fryer will no longer operate. If you have a multi
fryer system, the other fryers shouldn’t be
affected by this error. Contact Pitco Service or
Authorized Service Person for assistance.
There is NO reset from front controller panel.
4. If at any time you push “N” (0) key another
scrolling message “FRYER WILL BECOME
INOPERABLE”, “CONFIRM SHUT DOWN”
message.
5. If you press the “N” (0) key then the message
will revert to the display “Blocked Drain” as in
number 1. If you press the “Y” (6) key message
will display “Call Service – ERR” the fryer will
no longer operate. If a multi fryer system the
other fryers shouldn’t be effected by this error.
WARNING
DO NOT UNPLUG FRYER FROM SUPPLY
POWER. If the unit is unplugged and plugged in
again, you WILL damage your drain valve and
void the warranty.
L22-392 R1 21
To Next Page
Loading...
Need help?
General
