Pitco SSHLV Series - Replacing the Gas Valve

Pitco SSHLV (ROV) Gas Fryers
28 Replacing the Gas Valve
NOTE
Prior to moving, testing, maintaining or repairing
your appliance, ensure it is emptied of all oil,
cool, disconnected from gas and all electrical
power. Failure to do so may result in property
damage, damage to your fryer, injury or death.
1. Remove the pilot tubing from the gas valve
using a 7/16 inch open-ended wrench.
2. Disconnect the wiring connection from gas
valve.
3. Holding the elbow with a wrench, remove the
swivel nut on the bottom gas valve fitting using
a 1-1/16 inch open-ended wrench.
4. Holding the elbow with a 7/8” wrench,
remove the swivel nut on the top gas valve
fitting using a 15/16 inch open-ended wrench.
5. Remove the gas valve.
L22-392 Rev 1 58