Pitco SSHLV Series - Replacing the Frypot

Pitco SSHLV (ROV) Gas Fryers
31 Replacing the Frypot
!
DANGER
!
Prior to moving, testing, maintaining or repairing
your appliance, ensure it is emptied of all oil,
cool, disconnected from gas and all electrical
power. Failure to do so may result in property
damage, damage to your fryer, injury or death.
1. Remove the controller front panel (see
Section 5.1), gas valve (see Section 29), pilot
assembly (see Section 11), and burner
assembly (see Section 31.2).
2. Remove the baffle by pulling it out.
NOTE: For SSH models only.
3. Remove the drain manifold flange nut using a
9/16 inch close-ended wrench.
4. Loosen the collet using a spanner wrench.
5. Remove the collet.
6. Slide piping away from flange.
L22-392 Rev 1 64