Pitco SSHLV (ROV) Gas Fryers
13 Replacing the DC Power Supply
DANGER
Prior to moving, testing, maintaining or repairing
any appliance, ensure it is emptied of all oil,
cool, disconnected from gas and all electrical
power. Failure to do so may result in property
damage, damage to your fryer, injury or death.
1. Remove the one (1) 5/16 inch hex screw on
front of mounting box.
2. From the rear of the unit remove two (2) 5/16
hex screws from the small bracket that holds
the hose for the JIB.
3. In the rear of the unit disconnect the black
power cord from the entrance box, also remove
the red/black Molex connector.
4. You can easily remove entire mounting box
and power supply all in one piece.
5. Follow steps 1 through 4 in reverse order to
reinstall DC Power Supply.
L22-392 R1 33
To Next Page
Loading...
