Pitco SSHLV (ROV) Gas Fryers
7. Don’t forget gray rubber protector on the
thread of the clamp so they don’t get damaged.
When reassembling the actuator and valve,
remember to have the arrows in the motor
socket align with the end of the valve stem
slot. The valve and the actuator are indexed
to operate properly. Failure to align the
index marks will result in the valve being
opened when it supposed to be closed, and
vice-versa.
8. After servicing the powered drain system, If
the drain remains open, the motor and valve
assembly are not indexed correctly, remove
motor, and align marks as instructed
.
9. Should the drain valve need to be replaced,
first remove actuator per instruction in
section 4 of this chapter (drain valve comes
with actuator installed), then remove the old
drain valve from the end of the drain nipple
and install the new drain valve and actuator.
When installing the new drain valve, insure
the arrow on the valve body is pointed
AWAY from the drain nipple and towards the
filter pan.
L22-392 R1 32
To Next Page
Loading...
