Pitco SSHLV Series - Replacing the Filter Pump and Motor; Removing the Filter Pump and Motor

Pitco SSHLV (ROV) Gas Fryers
33 Replacing the Filter Pump and Motor
33.1 Removing the Filter Pump and Motor
NOTE
Photos are for illustrative purposes only and
may not be an exact match to your appliance..
1. Remove filter pan and filter pan cover.
Loosen the pump inlet tube using a crescent
wrench.
2. Unscrew and remove the inlet valve of the
filter pump system.
!
DANGER
!
Any and all spilled oil, water or other liquids that
occurs as a result of operation, cleaning,
maintenance or repair of this fryer should
immediately be cleaned and dried. Failure to do
so can create a slippery surface resulting in
falling/impact injury or death.
3. Pull out pump inlet tube.
4. Remove filter pan cover (not shown).
5. Disconnect the connections and power
supply cords from the filter pump.
L22-392 Rev 1 72