Pitco SSHLV (ROV) Gas Fryers
6. Remove the lower connection at the 3-way
return valve using a 15/16 inch wrench.
7.Using a 1” inch wrench remove the JIB hose.
8. Remove one (1) screw, which holds a
bracket which is underneath the ON/OFF
breaker switch using a 5/16 inch socket.
9. Remove the rear hair pin on the actuator.
10.Remove the bracket.
The filter pump will fall to the floor once the
pins are pulled out. It is recommended that
you brace the pump and motor before
L22-392 Rev 1 73
To Next Page
Loading...
