Pitco SSHLV (ROV) Gas Fryers
22 Removing the Filter Pump from the Motor
1. Remove the two (2) bolts holding the filter
pump head to the motor using a 1/2 inch open-
ended wrench.
2. Remove the filter pump head from the motor.
3. Reinstall the filter pump head to the motor by
following steps 1 through 2 in reverse.
22.1 Replacing Seal Kit
1. Remove the four (4) bolts on filter pump
using 7/16 inch open-ended wrench.
2. Remove the filter pump head.
3. Replace the seal.
4. Reinstall the filter pump head to the motor by
following steps 1 through 3 in reverse.
L22-392 Rev 1 48
To Next Page
Loading...
