Pitco SSHLV (ROV) Gas Fryers
15 Changing Filter Pump Actuator
1. Pull two (2) re-usable cotter pins. One is
located in the front of the actuator unit, second
is located in the rear of the actuator.
2. From the front, unplug the four pin molex
connector for the actuator.
3. Remove filter pump actuator.
4. Follow steps 1 through 3 in reverse to
reinstall new filter pump actuator.
Re-assembly is simplified if the cotter pin in
the rear is installed BEFORE the cotter pin
in the front of the fryer.
L22-392 R1 35
To Next Page
Loading...
