Pitco SSHLV (ROV) Gas Fryers
23 Replacing the Drain Line or Gasket
1. Remove one (1) screw on the drain line using
a 7/16 inch wrench.
2. Lift off the drain manifold clamp.
3. Slide off the drain manifold gasket.
4. Slide out the drain line.
5. Reinstall the new drain line by following steps
1 through 4 in reverse to.
DANGER
Any and all spilled oil, water or other liquids that
occurs as a result of operation, cleaning,
maintenance or repair of this fryer should
immediately be cleaned and dried. Failure to do
so can create a slippery surface resulting in
falling/impact injury or death.
L22-392 Rev 1 49
To Next Page
Loading...
