Pitco SSHLV Series - Replacing the Controllers; Removing the Controller Front Panel Bezel

Pitco SSHLV (ROV) Gas Fryers
5 Replacing the Controllers
5.1 Removing the Controller Front Panel Bezel
1. Remove the two (2) screws on the controller
panel using a Phillips screwdriver. (on a Dual
unit you will need to remove the front panel
divider).
(For a dual unit- remove the front panel divider)
2. Pull out the controller panel front bezel.
3. Disconnect the controller wiring harness.
L22-392 R1 19