Pitco SSHLV (ROV) Gas Fryers
11. Turn down the pins and then pull them out.
12. ROV units with a solofilter, will require the
removal of the RH pan guide rail to allow the
pump to be lowered as shown (Filter pan rails
are not shown). Lower the filter pump to the
floor and then pull it out.
13. Remove the three (3) bolts on the bottom of
the filter pump base using a ½ inch open-ended
wrench.
14. Remove two (2) screws on back of filter
pump using a 5/16 inch socket.
15. Remove existing piping from old filter pump
using two adjustable wrenches.
16. Reinstall a new filter pump by following
steps 1 through 13 in reverse.
L22-392 Rev 1 74
To Next Page
Loading...
