Pitco SSHLV Series - Page 65

Pitco SSHLV (ROV) Gas Fryers
7. Remove the flange elbow.
! DANGER !
Any and all spilled oil, water or other liquids that
occurs as a result of operation, cleaning,
maintenance or repair of this fryer should
immediately be cleaned and dried. Failure to do
so can create a slippery surface resulting in
falling/impact injury or death.
8. Remove the control box and wiring harness
for each fryer that shares a common top deck.
9. Remove the four (4) screws per fryer, which
hold the top deck down, using a 5/16 inch
socket.
10. Remove the top deck by pulling up.
11. Remove the six (6) screws, which hold the
back of the splash back, using a 5/16 inch
socket.
12. Score the silicon sealer between the front of
the splash backs using a flathead screwdriver
or utility knife.
13. Remove the two (2) screws, which hold the
front of the splash back, using a flathead
screwdriver.
L22-392 Rev 1 65