Pitco SSHLV Series - Page 66

Pitco SSHLV (ROV) Gas Fryers
14. Remove the splash back by lifting up.
15. Remove the six (6) screws, which hold the
tank to the cabinet, using a 5/16 inch socket.
16. Remove the channel strip by pulling up.
17. Score the silicon sealer between the tanks
using a flathead screwdriver or utility knife.
18. Remove high-limit and temperature probes.
See Replacing Ignition Module and Hi-limit
Section 10.
19. Remove the two (2) screws, which hold the
top deck support, using a 5/16 inch socket.
L22-392 Rev 1 66