Pitco SSHLV (ROV) Gas Fryers
6. Remove the fittings and plate from the gas
valve using a 7/8 inch open-ended wrench.
7. Install the heat shield, vent tube, and fittings.
8. Reinstall a new gas valve by following steps
1 through 8 in reverse.
DANGER
Check for gas leaks after installation or servicing
of a gas fryer. Apply a leak detection solution to
all connections and joints to ensure there are no
bubbles or leaks. Failure to check for and correct
any leaks could lead to fire and/or explosion,
property damage, injury and death.
L22-392 Rev 1 59
To Next Page
Loading...
