24 - ATR224 - DRR224 - User manual
87
L.L.P.1
Lower Limit Output Percentage 1
Selects min. value for command output percentage.
%...%, Default: %.
88
U.L. p.1
Upper Limit Output Percentage 1
Selects max. value for command output percentage.
%...%, Default: %.
89
m.G. t.1
Max Gap Tune 1
Selects the max. process-setpoint gap beyond which the automatic tune recalculates PID
parameters of process .
- [digit
p.
] (degrees.tenths for temp. sensors). Default: .
90
m n . p .1
Minimum Proportional Band 1
Selects the min. proportional band value selectable by the automatic tune for the P.I.D.
regulation of process .
- [digit
p.
] (degrees.tenths for temp. sensors). Default: .
91
m a. p.1
Maximum Proportional Band 1
Selects the max. proportional band value selectable by the automatic tune for the P.I.D.
regulation of process .
- [digit
p.
] (degrees.tenths for temp. sensors). Default: .
92
mn.i.1
Minimum Integral Time 1
Selects the min. integral time value selectable by the automatic tune for the P.I.D. regulation of
process .
..... seconds. Default: . s.
93
o . c.L.1
Overshoot Control Level 1
The overshoot control function prevents this event during device switching on or when the
setpoint is modified.
Setting a too low value the overshoot may not be fully absorbed, while with high values the
process could reach the setpoint more slowly.
Disab.
Lev.
Lev.
Lev.
Lev.
Lev. (Default)
Lev.
Lev.
Lev.
Lev.
Lev.
94÷97 Reserved Parameters - Group E
Reserved parameters - Group E
To Next Page
Loading...
Need help?
General
