Planar PS5074K - Basic Remote Functions; Turning the Display on; Turning the Display off; Adjusting the Volume

Operating the Display
Planar PS Series 4K Displays User Manual
020-1384-00C
Page | 28
17. Basic Remote Functions
17.1 Turning the Display On
1. Insert the power cord into the display and into the power outlet.
2. Ensure the AC switch is set to “—“.
3. Press the power button on the remote or keypad.
17.2 Turning the Display Off
With the power on, press the power button on the remote or keypad to put the LCD panel in a
standby mode. To turn off power completely, turn the AC switch to “O” or disconnect the AC power
cord from the power outlet.
Note: If there is no signal for a certain period of time, the LCD panel will automatically go into standby
mode.
17.3 Adjusting the Volume
1. Using the remote, press the VOL- or VOL+ to increase or decrease the volume.
2. Pressing the MUTE button temporarily turns off all sound. To restore the sound, press the
MUTE button again.
Note: The analog audio out is variable. S/PDIF is fixed.
17.4 Selecting the Input Source
Press the INPUT button on the remote or press the Source button on the keypad. Use the arrow
buttons (
) to select one of the following input sources: DP, HDMI1, HDMI2, VGA, Android, and
press ENTER.
Note: When the display cannot find a source, a “No signal” message will appear.
17.5 Navigating Through the Menus
1. With the power on, press MENU. The main menu appears.
2. Within the menu, use
, , , , and ENTER to navigate through the menus and
adjust options.
3. Press MENU to return to the previous menu. To exit the menu system, press EXIT.