14
Step 5. Wiring the DC Outputs
Please follow the steps below to insert the power wires for DC power required
equipment.
1. Please nd the terminal block connector with two DC power outputs shown
below:
V1+
V2+
V1-
V2-
2. Insert the Positive and Negative DC wires into the V+ and V- terminals,
respectively; Terminals 1 and 3 for Power 1, and Terminals 2 and 4 for Power 2.
3. Connect the other points of DC power wires to the power devices. Tighten the
wire-clamp screws for preventing the wires from loosening.
V1+
Reset
V2+
DC Ouput: 24V , 2A max.
Maximum Output 48 Watts
Powered
Device
1
V1+
V2+
V1-
V2-
One Powered Device
V1+
Reset
V2+
DC Ouput: 24V , 2A max.
Total Maximum
Output 48 Watts
Powered
Device
Powered
Device
1
2
V1+
V2+
V1-
V2-
Two Powered Devices
To Next Page
Loading...
