User Manual of WDAP-C3000AX, WDAP-3000AX, WDAP-W3000AX
- 46 -
Step 2: LAN Interface
Set up the IP Address and Subnet Mask for the LAN interface as shown in Figure 5-5.
Figure 4-8: Setup Wizard – LAN Configuration
Enter the IP address of your router. The default is 192.168.1.1.
An address code that determines the size of the network. Normally
use 255.255.255.0 as the subnet mask.
By default, the DHCP Server is enabled.
If user needs to disable the function, please uncheck the box.
By default, the start IP address is 192.168.1.100.
Please do not set it to the same IP address of the router.
By default, the maximum DHCP users are 101, which means the router
will provide DHCP client with IP address from 192.168.1.100 to
192.168.1.200 when the start IP address is 192.168.1.100.
Press this button to the next step.
Press this button to undo any changes made locally and revert to
previously saved values.
To Next Page
Loading...
Need help?
General
