SECTION I: General Information
SAFETY INSTRUCTIONS
The operating procedures outlined in this manual are prepared to
facilitate the successful operating of the XL2 machine.
1) KEEP ALL SAFETY DEVICES IN PLACE and in working order.
2) KEEP WORK AREA CLEAN. Cluttered areas invite accidents.
3) DO NOT USE IN DANGEROUS ENVIRONMENT. Do not use machines in a damp
or wet location, or where any flammable or noxious fumes may exist. Keep work
area well lit.
4) KEEP UNAUTHORIZED PEOPLE AWAY. All unauthorized people should be kept
out of work area and away from machine.
5) DO NOT FORCE MACHINE. It will do the job better and safer at the rate for which it
was designed.
6) USE THE RIGHT MACHINE. Do not force machine to do a job it is not designed to
do.
7) DO NOT USE UNDER THE INFLUENCE OF DRUGS OR ALCOHOL
8) DIRECT ELECTRICAL CONNECTION TO WALL SOCKET IS HIGHLY
RECOMMENDED. If use of extension cord is necessary, make sure your extension
cord is UL and CE approved and in good condition. Your extension cord must also
contain a ground wire and plug pin. Always repair or replace extension cords if they
become damaged.
9) WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neckties, rings,
bracelets, or other jewelry that may get caught in moving parts. Wear protective hair
covering to contain long hair.
10) MAINTAIN MACHINE WITH CARE. Keep machine clean for best and safest
performance. Follow instructions for lubricating and keeping machine free of lint.
11) DISCONNECT MACHINE before servicing and when changing spool.
Page 6
To Next Page
Loading...