Platemeters F200 - P-Plus Software Installation; Downloading the P-Plus Software

14 | F200 and F300 User Manual
7 - Things to do before you start your walk
The F200 and F300 Platemeters can be used immediately out
of the box, but you P-Plus installed on your computer before
you need can enter or load data from your first walk.
If P-Plus is not installed, refer to the section below. When P-Plus
software is installed on your computer, you’ll need to setup your
farm by creating:
• aproperty
• paddocks
• equations
• denethewalkorder.
- Ensure you are not using the demonstration farm.
- Start Up / Self-Test – see section a.3.
- Enter or choose your equation. See Section 10.
8 - P-Plus Instalation
This section outlines the basic instructions for installing
P-Plus on your computer. For more detailed information about
using P-Plus, please visit our website www.platemeters.co.nz
Alternativly help can be found in P-Plus by pressing the F1 key
on your keyboard at any point. This will bring up help relative to
the P-Plus window you have open at the time.
8.1 Download Link
To download P-Plus visit:
platemeters.co.nz/pages/p-plus-pasture-software.
When you select the link, you will be taken to a drop box page
with a blue download button. Click the blue button and select
‘Direct Download’.