F200 and F300 User Manual | 19
9.2 F300 Front Display Buttons
The various functions of the F300 are accessed by the four
Buttons on the front of the unit labelled
- Disp/Enter
- Avg/Reset
- Count/Menu and the
- Up/Down arrow buttons
The wordings in bold type are the primary functions.
These are activated by a short press of the button. The
secondary functions in normal type are activated by
holding the button down until the function operates
- Disp/Enter - shows the current paddock number
selected (1 – 100).
- Up/Down arrows - used to scroll back and forth in some
options.
- Count - the number of readings is displayed. The
display will show a ‘c’ on the left side and the count on
the right. Holding the button down will take you to a
menu of other options described in sections 9 and 11.
- Avg/Reset - Pressing this button briefly for ‘Avg’ will
display the average height of your readings in clicks
(0.5cm). Holding it down for ‘Reset” will save the
average height to memory and reset all data ready for
the next paddock.
9.3 Startup / Self-test
- Switch On. The unit will beep and display ‘F200’ or
‘F300’. It may also beep 3 times and display ‘Lo’ if the
battery needs recharging. The current formula in use
will be displayed next with the ‘+’ part of the equation
first (default 500) and then the ‘x’ part second (default
140). The display will then show the kgDM/ha calculation
based on that formula and any readings stored in
memory.
- To clear the readings, press and hold the ‘Reset’ button
until the display shows ‘0.0’
To Next Page
Loading...