F200 and F300 User Manual | 27
- When you have completed the paddock, you can press
the ‘Avg’ button to show the average pasture cover,
although the F200 will default to kgDM/Ha.
- Write down the average height and/or the average cover.
- Repeat until you have completed every paddock.
- Switch the unit off using the toggle switch at the back.
12.2 F300 Pasture Walk
The F300 has the ability to save the recorded “average
height readings” to a specific paddock number that
you select on the F300. These readings can then be
downloaded from the F300 (via the mini USB cable) and
associated with your paddocks in your walk order (which
you need to have pre-defined in your P-Plus software
program).
- Switch the unit on using the toggle switch at the back of
the unit.
- If you are starting the first paddock, you will need to
make sure the F300 does not contain any old data.
- Press and hold the reset button until the display
changes to ‘0’. This should be accompanied by 2 short
beeps.
- Now press and hold the ‘Menu’ button. Press the ‘arrow’
button twice until you see P CL (paddock clear).
- Now press ‘Enter’ All recorded paddock data will be set
to ‘0’. Including any unsaved data in memory.
- Press and hold the ‘Enter’ button you will see E_ _
1. Pressing the ‘arrow’ button will scroll the numbers
upwards. If you want to scroll back, hold the ‘Count’
button while briefly pressing the arrow button. The
number will change to the previous paddock number.
The arrow (on its own) will now scroll the numbers
backwards. Stop at the number (this maybe your walk
order number) you want to record and press ‘Enter’.
To Next Page
Loading...