Platemeters F200 - View Saved Paddock Data; Delete Single Paddock Data

F200 and F300 User Manual | 29
- When you have completed the paddock, hold the ‘Reset’
button. You will first be shown the average height of the
paddock, which is then saved to memory under that
paddock number. A small triangle icon will appear in
the top left-hand corner, indicating that paddock now
contains data.
- You will then need to select the next paddock.
Repeat this process until you have completed every
paddock.
12.2.1 View Saved Paddock Data
You can view the saved paddock data and paddock
numbers at any time by pressing the arrow key. The
display will first show the paddock number and the
average height that was recorded. Pressing the arrow
key again will show the next paddock with data in it.
Once the last recorded paddock (thus far) is displayed
the F300 will beep and return you to the normal display.
However, you can escape the paddock display function
at any time by pressing ‘Disp’.
12.2.2 Delete Single Paddock Data
To clear the data in a single paddock, press and hold the
ENTER button until you see E (n). Change the number to
the desired paddock and press ENTER. Now press and
hold the reset button. The display will show a “0”. Press
and hold the reset button again. The display will remain
at 0 and the triangle icon in the top left will disappear.
That paddock data has been deleted.