Plum ecoMAX810P3-L TOUCH User Manual

21
9 Service - Menu structure
Service settings.
Boiler settings
CH and HUW settings
Mixer 1-4 settings*
Show advenced setup NO / YES
Restore defaults settings
Touch screen calibration
Boiler settings
Firing-up
Output modulation
Burning off
Supervision
Lambda sensor*
Thermostat selection*
Min boiler temperature
Max boiler temperature
Minimum airflow output
No fuel detection time
Ex.temp.w.no fuel
Reserve boiler*
Alarms
Boiler cooling temperature
Parameter A FL
Parameter B FL
Parameter C FL
Firing-up
Firing-up airflow
Ignition test time
Ignition test time 2
Feeding time
Firing-up time
Ex.temp.delta
Ex.temp.delta 2
Ex.temp.at the end of fired-up
Test dose
Output modulation
100% Blow-in output
100% Feeder operation
100% Feeder interval
50% Blow-in output
50% Feeder operation
50% Feeder interwal
30% Blow-in output
30% Feeder operation
30% Feeder interval
Burning off
Buring off time
Air flush intensity
Supervision
Supervision time
Feed time
Feed interval
Airflow oper.extend
Lambda sensor*
Operation with Lambda sensor
Parameter A Lambda
Parameter B Lambda
Parameter C Lambda
Airflow correction range
Feed lock
Fuel detection - oxygen
Fuel detection - time
CH and HUW settings
CH pump activation temp.
CH pump standstill when load. HUW
Min. HUW temp.
Max. HUW temp.
Boiler inc. by HUW, Mixer
Extending HUW pump operation time
Exchanger
Boiler pump lock
Mixer 1-4 settings
*
Mixer support
Thermostat selection
Min. mixer temp.
Max. mixer temp.
Proportional range
Integr. time const.
Valve opening time
Pump off by therm.
Mixer input dead zone
*- menu for all mixer cycles is identical

Plum ecoMAX810P3-L TOUCH Specifications

General

Brand	Plum
Model	ecoMAX810P3-L TOUCH
Category	Controller
Language	English