Windshield Mounting:
1. Install the suction cups into the mounting
bracket by sliding them into their holes
(if not pre-installed).
2. Do not loosen the screw at the pivot point
where the two-piece bracket is assembled
(see illustration on page 14).
3. Insert the small plug end of the 12-volt
adapter into the jack marked “POWER”,
located on the back of the compass and
plug the large plug end into your cigarette
lighter receptacle.
4. With the battery and/or 12-volt adapter
installed, slide the unit all the way into
the shaped compass holder until you
hear/feel the “click” when the locking
ngers slip into place.
INSTALLATION
To Next Page
