HEADER
10
Step 3: Installing the external
temperature sensor
The PNI V6000 has a built-in internal
temperature sensor designed to measure
the temperature inside the vehicle at the
windshield (“IN TEMP”).
The PNI V6000 also includes a wire
temperature tether designed to measure
the temperature outside the vehicle (“OUT
TEMP”). The sensor end of the tether
must be mounted outside of the passenger
compartment, away from engine heat or
direct sunlight, in a place where there is
natural airow to the sensor, such as in the
grill area or door jamb. It is best to adhere the
sensor on a surface that is least conductive
to heat -- such as on a rubber or plastic
surface as opposed to the steel body of the
vehicle. The temperature from this sensor is
displayed as “OUT TEMP.”
Every vehicle is different, making it impossible
to list all possible sensor locations. Use
your best judgment to select the site for
the temperature sensor and experiment with
various locations, if necessary.
INSTALLATION
To Next Page
Loading...
