17
Calibrating the unit
To begin calibration, press to toggle
through the programming options until
“CALIb” and “SEt” display on screen.
1. Press .
“PrESS StEP to StArt” displays.
If is pressed now, the unit returns to
normal display.
2. Press .
“turn ONCE PrESS Ent to End” displays.
Turn vehicle in one complete circle in either
direction. Circle size does not matter. Take
at least 20 seconds to complete the circle.
3. Press .
“dONE” ashes once, and the unit returns to
normal display mode. If the degree symbol
on line 2 ashes after calibration, repeat
the calibration process. A ashing degree
symbol indicates magnetic distortion. See
the Frequently Asked Question section for
more information.
PROGRAMMING AND OPERATION
To Next Page
Loading...
