point pro Series - Page 22

22
Mattress Brush
1. Press the Button (g) and remove the brush cover.
2. Take out the roller brush and remove the blockage. If the blockage
too tight, use knife or scissors to cut it along the groove on the roller
brush. Remove all the waste in the roller brush.
3. Re-install the roller brush. Ensure the belt inside the brush housing
go around the gear part of the roller brush. Check the roller brush
rotate properly.
4. Install the brush cover.
Clean the Mattress brush (Z) when the roller brush jammed:
g
Z
1
2
3
4