CelloTrack LTE Plus Overview
CelloTrack XT LTE Overview.docx Page 13 of 40
Copyright © 2020 by Pointer Telocation, Ltd.
CelloTrack Power 3G
NA Evaluation Kit
PN: K080-001
Evaluation kit for the CelloTrack
Power 3G NA.
------------------------------------------------------------------------------------------------
WARNING: The Communication Harness used for the CelloTrack T family and the
CelloTrack LTE (PN 711-00251) is different from the one used for the legacy CelloTrack
(PN 711-00278). Using the wrong Communication Harness can damage the electrical
circuit of the CelloTrack T, and require repair at the Cellocator premises (RMA).
Therefore only the correct Communication Harness, easily differentiated by its red
label, should be used.
------------------------------------------------------------------------------------------------
3.6 The CelloTrack Cradle
The CelloTrack Cradle is designed to be mounted on the surface of a mobile asset and
to firmly hold the CelloTrack unit. The cradle supports mounting on a surface by
double-sided adhesive tape or by using screws. The cradle also supports a setup with
four POT magnets, allowing instant attachment to metal (iron) surfaces.
The unit can be easily placed into the cradle using the cradle side snaps. The cradle
also supports securing the CelloTrack in the cradle by using four cable ties.
Detection of removal of the cradle from the mounting surface (cradle tamper
detection) is also supported.
To Next Page
Loading...
General