CelloTrack LTE Plus Overview
CelloTrack XT LTE Overview.docx Page 23 of 40
Copyright © 2020 by Pointer Telocation, Ltd.
There are 2 models of MultiSense: regular devices that can measure temperature
called "MultiSense", and "MultiSense-TH" devices which have a combined temperature
and humidity sensor.
The MultiSense device has the following sensors:
Temperature sensor
Humidity sensor (only in the MultiSense-TH model)
Hall effect magnetic sensor
Ambient Light Sensor (ALS)
Accelerometer sensor
The CelloTrack 10y supports up to 16 fully programmable MultiSense devices.
If "Guest mode" is enabled (via the Guest and Tag MultiSense reporting parameter),
the unit will also connect with MultiSense units not in its list, read their sensors and
pass the data (in raw format) to the server. Only listed MultiSense units also get
configuration blocks and their readings are fully processed by the 10y.
If "Tag mode" is enabled, the 10y unit will only report on existence (reception of
advertisements) of unpaired MultiSense units, not reading their sensors.
MultiSense devices can be paired with the unit by entering the MultiSense MAC
address, which is written on the MultiSense, in the MultiSense Editor window accessed
via the Cellocator Programmer.
4.6 CelloTrack Feature List
The following list details the features and capabilities of the CelloTrack family. These
features are actually a combination of the Fleet management capabilities derived from
Cellocator’s Cello product line and specific asset management capabilities designed
solely for the CelloTrack family.
Geo-Fences (100)
Way Points
Roaming List (100)
Usage counters (PTO)
Server authentication
Automatic SIM PIN lock
DNS support
Virtual odometer
Jamming detection
Road curve smoothing
Cell-ID report
Offline Tracking
Wake up event
Movement detection
Crash detection
Time based events (adaptive to movement status)
Specific time (in day) reporting
To Next Page
Loading...
General