EasyManuals Logo

Pointer Cellocator CelloTrack XT LTE User Manual

Pointer Cellocator CelloTrack XT LTE
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
CelloTrack LTE Plus Overview
CelloTrack XT LTE Overview.docx Page 29 of 40
Copyright © 2020 by Pointer Telocation, Ltd.
You can configure the unit to work in one of the following tracking modes, and which
are described in the following sections:
Error! Reference source not found.
Error! Reference source not found.
Error! Reference source not found.
Improved (Take Location) Tracking Mode
BOD/EOD Tracking Mode
5.3.1 Live Tracking
The unit is fully active and sends periodic updates to the server. This is not the default
tracking mode.
5.3.2 Tracking with GNSS Peeking
This tracking mode is similar to live tracking but uses less battery power: the GNSS
module operates in peeks just before each time event (instead of permanent
activation) and only if:
Time events are enabled and the time event interval is longer than 90 seconds.
One valid GNSS fix has already been set.
The GNSS module is switched off immediately after the time event message is
generated.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pointer Cellocator CelloTrack XT LTE and is the answer not in the manual?

Pointer Cellocator CelloTrack XT LTE Specifications

General IconGeneral
BrandPointer
ModelCellocator CelloTrack XT LTE
CategoryGPS
LanguageEnglish